It runs, but doesn't communicate with the radio MySensors]#. Linux netberry 6.1.11-2-rpi-ARCH #1 SMP PREEMPT Tue Feb 14 06:34: aarch64 GNU/Linux configure and hal/transport/RFM69/driver/new/RFM69_new.h as described git]# cat /proc/cpuinfo | grep Model & uname -a

I got it compiled on Arch Linux ARM with the aarch64 linux-rpi kernel after editing. I am not sure if this is just a communication problem that will be solved with the capacitor, or the issue is with Home Assistant which is not detecting the NRF24L01, or with the NRF24L01, not being a NRF24L01+ (I have just noticed it)Īm I doing it right? Is this the right way of connecting a mysensor to a HASSIO installation on a Raspberry Pi? I have NOT connected a capacitor yet (have to order it) in the NRF24L01 of the RasPi but I have placed both emitter and receptor close to each other with no difference. On the RF-NANO I load the example sketch from here:

I assume that this is because there is no sensor connected yet, but I'm still not sure. Issues: First, Home Assistant should recognize the NRF24L01 and assign it to a /dev/ttyXXXX but it is not happening. On the Raspberry Pi I have connected a standalone NRF24L01 to the gpio following this:

When running a simple arduino sketch to read the DHT11 it works fine. The sensor is connected to a Keywish RF-NANO board (it's a nano clone with a NRF24 in the same board). I am trying to add a DHT-11 sensor (as the first shot with MySensors). I have a working HASSIO (0.100.2) installation running on a Raspberry Pi 2+. First time trying MySensors, it's not working, and I am not sure if I am following the correct approach:

Hassio raspberry pi zero w